2017 Chevrolet Suburban
Mileage
80,310
Service Date
11/17/2022
Services Performed
- Road tested vehicle. Performed complete brake system inspection. The following is amount of brake lining remaining: –Front Brakes Technician Note: 8mm or greater pad thickness remaining. It appears somebody installed metallic pads on the front instead of the factory recommended ceramic. The brake pads appear to be wearing the rotors. Recommend to install OE QUALITY BRAKE PADS – Recommendation: Replace front brake pads and rotors with oem quality parts. –Front Rotors Technician Note: Brake rotors were found worn lower than specified thickness allowed for resurfacing. Rotor replacement will be required if any brake repair is performed. – Recommendation: REPLACE ROTORS – We recommend replacing front rotors due to concerns found on inspection. –Rear Brakes Technician Note: 10 mm – Recommendation: Scuff pads machine rotors –Rear Rotors Technician Note: Brake rotors were measured. We found them within specified thickness allowed for resurfacing. There is some glazing present. Rotor resurfacing is recommended if any brake repair is performed. – Recommendation: MACHINE REAR ROTORS – We recommend turning rear rotors on our brake lathe due to concerns found on inspection. –Parking Brake Technician Note: Inspect parking brake shoes and advise during repair. Rotors must be removed inspect parking brake shoes Inspected brake hydraulic system for leaks, wear and condition of fluid.
- The technician verified the customers concerns. Performed systems checks for the rapidly flashing turn signal indicator. Found one left rear turn signal bulb inoperative. Removed all parts necessary to gain access to the left rear turn signal bulbs. Found both bulbs burnt out. Installed two new left rear turn signal bulbs. Reassembled all necessary parts and verified the bulbs now work and the turn signal indicator flashes correctly now. Performed inspection for the power lift gate issue. Scanned for codes and found code B153E-08 Lift gate sensor circuit issue. This code detects inconstant signal from the liftgate position sensor #1 and #2. This could be a faulty latch, faulty wiring or a faulty liftgate control module. We will need to diagnose further at a later date to find and repair the issue.
Miranda G. gave our service a 5 star review on 11/17/2022
